Assigning control change messages to the knobs and other controls (user page)

You can select the control change messages you desire that are assigned to the knobs, and register them on a ded­icated page (the user page). Use this to customize the CC messages so that they’re more appropriate for your sound generator.

 

Scenes with preset user pages are available for the following software sound generators. Select the scene that matches the software sound generator you’re using.

•wavestate native, opsix native, modwave native, microKORG, TRITON, Polysix

→Switching between scenes

Tip:With the user page, you can also assign control change messages for the modulation wheel, key velocity and aftertouch.

Tip:You can use KORG Kontrol Editor as well to register the data. For details, visit the Korg website (www.korg.com).

Assigning to a user page

Here’s an example of how to assign CC messages to the user page. This example shows how to assign CC#10 (knob 3) from edit page 2 to knob 1 of the user page.

 

1Press the EXIT button to access the main screen.

2Press the PAGE — or + button to access the page containing the control change message you want to assign.

In this example, we go to page 2 where CC#10 is.

 

3Press the WRITE button while holding down the SHIFT button.

 

4Turn the knob of the control change message you want to register to the user page.

The sub display that corresponds to that knob blinks. Turn knob 3 to select “CC#10”.

 

5Turn the VALUE dial. On the main display, select the controller to which you want to register the CC message.

In this example, select “UsrPg Knob1” (knob 1).

 

By selecting a knob from 1 to 8, the CC message is registered to the corresponding knob on the user page.

Indication

Controllers

UsrPg Knob1–UsrPg Knob8

Knobs 1–8

Modwheel

Modulation wheel

Velocity

Keyboard velocity

Aftertouch

Aftertouch

None

No assignment

6To register, press the WRITE button.

The display returns to the main screen.

 

The user page settings are included in the scene data. Any settings that you’ve edited are lost if you turn off the power or select another scene without saving it.
→Switching between scenes

 

When connected via MIDI 2.0 Property Exchange, the settings cannot be registered to a user page, as the CC numbers are automatically assigned.

Recalling the user page

 

1On the main screen, press the PAGE —/+ buttons to select “User Page”.

 

Note:The user page is only shown when it is registered.

2Turn the knob to adjust the control change message that you’ve assigned.

Resetting the user page

Here’s how to reset all of the settings of the user page to their unregistered state.

 

1Press the EXIT button to access the main screen.

2Hold down the WRITE button while holding down the SHIFT button.

Once the user page is reset, the message “User Page Cleared!” is shown.

Note:This resets the user pages for the control change and for the arpeggiator.