You can save or recall the knob or arpeggiator settings (scene data) in bulk as a scene.
Sixteen scenes can be saved on the Keystage. By preparing a scene that matches each sound generator to be used and each performance situation, you can instantly switch between these settings on the Keystage.
Scenes 1–6 have preset user pages for use with software sound generators. Select the scene that matches the software sound generator you’re using.
Scene 1: wavestate native
Scene 2: opsix native
Scene 3: modwave native
Scene 4: microKORG
Scene 5: TRITON
Scene 6: Polysix
Note:The wavestate native LE software is bundled with the Keystage. All other software sound generators can be purchased separately.
|
|
You are free to edit the contents of scenes 1–6. However, if the user page settings differ from the factory default settings, you may not be able to properly control a software sound generator with this instrument. |
Tip:You can use KORG KONTROL Editor to manage and edit the scenes. Download the software from the Korg website, and then set it up according to the instructions in the supplied document.
https://www.korg.com/keystage_editor/
Here’s how to save the current sound settings to a scene. Make the settings on the Keystage as you want them to be saved, and then follow these steps.
1Press the EXIT button to access the main screen.
2Press the WRITE button.
The screen for selecting the save destination appears.
3Turn the VALUE dial to select the number of the destination where you wish to save the scene.
4Press the WRITE button again.
The screen for inputting the scene name appears.
5Use the VALUE dial and the PAGE —/+ buttons to input the scene name.
You can use the VALUE dial to edit the characters, and use the PAGE —/+ buttons to change the input position.
6To save, press the WRITE button.
Once the data is saved, the message “Saved!” appears.
Recalls a saved scene.
1Press the EXIT button to access the main screen.
2Press either of the PAGE —/+ buttons while holding down the SHIFT button to select a scene.