Operating the sound parameters

Control change messages (CC#0 through CC#127) are pre-assigned to knobs 1–8 of the Keystage. You can oper­ate the parameters of the sound generator while switching between the eight control change groups (pages).

Check the control change numbers beforehand that are assigned to the parameters of your sound generator.

 

Tip:If you’re using a sound generator that supports MIDI 2.0, the sound generator’s parameters are automatically assigned to knobs 1–8. For details, visit the Korg website (www.korg.com).

 

1Press the EXIT button to access the main screen.

2Turn knobs 1–8 to adjust the parameters of the sound generator.

The control change numbers that correspond to the knobs are shown in the sub display.

 

3Press the PAGE — or + button to switch between pages.

The number of the current page and the total number of pages are indicated on the main screen.

 

When you’re switching between pages or when you switch to play a different sound generator, you may notice some discrepancies between the knob position and parameter value. If this happens, turn the knob to immediately reset the parameter’s value to the knob’s position.

Tip:To assign your favorite control change messages to other knobs, use the dedicated pages (user page) to register your custom settings.
→Assigning control change messages to the knobs and other controls (user page)