Turning the power on and off
Note: Before turning the power on, make sure that the volume is turned all the way down on your other devices.
If you’ve connected equipment such as monitor speakers, turn the power on/off in the following order.
Turning the power on
1Turn the volume all the way down on the devices you want to connect the microKORG2 to.
2Long-press the power button on the microKORG2 to turn the instrument on.
3Turn on your external output devices such as monitor speakers.
Turning the power off
1Turn the volume all the way down on all devices.
2Turn off your external output devices such as monitor speakers.
3Long-press the power button on the microKORG2 to turn the instrument off.
|
|
Do not turn off the instrument while it is processing, such as when saving data. This may corrupt the data in the microKORG2’s memory. |
The microKORG2 automatically turns off if is not operated for 20 minutes (auto power-off). This setting can be adjusted.
1Press the EDIT GLOBAL button to access the [1/5 GLOBAL] page.
2Turn the EDIT CONTROL 5 knob to make the setting.
Disable: disables the setting
Enable: enables the setting (the power turns off automatically if 20 minutes elapse without any user input)
Auto power-off does not activate in the following conditions.
•When you are operating the front panel buttons or knobs, playing the keyboard or using other controls
•When you are using the arpeggiator in latch mode
•When the loop recorder is playing back or recording
•When an input signal is being received from the MIC IN or AUX IN jacks
•When receiving MIDI messages other than MIDI clock