Display

Home page

•Press the FUNCTION 5 button to show the home page.

 

 

Status

MIC: Indicates the input signal detected for the MIC CONDENSER and DYNAMIC jacks.
Black: no sound; green: input detected; red: input overload

AUX: Indicates the input signal detected for the AUX IN jack.
Black: no sound; green: input detected; red: input overload

LOOP: Indicates the recording length for the loop recorder.

BPM: tempo

Power:  Hi,  Low,  Alert,  Empty,  Now Measuring
Shows the remaining battery power in steps.

: when using an AC adapter

Program

Shows the currently selected program number, name, genre and bank.

PROGRAM NUMBER
Program Name
Genre
BANK

→ Selecting programs

Performance Edit

Use the EDIT CONTROL knobs 1 through 5 to make changes to the parameters assigned to each knob while you’re playing, which alters the sound. → Using Performance Edit to modify the sound

Functions

The various functions that the FUNCTION 1–5 buttons can perform.

INC, DEC: Increases or decreases the value of the parameter that’s being edited, one step at a time. Use the EDIT CONTROL 1–5 knobs to select the parameter for which you want to change the value.

Tip: Turn the EDIT CONTROL 1–5 knobs while holding down the FUNCTION 5 button to select a parame­ter without changing the values.

 

SCOPE: Shows the oscilloscope.

 

 

 

WRITE: Saves the current program. Press this button to show the rename, save program and cancel menu options. → Writing a program

FUNC/HOME: Hold down the FUNC (FUNCTION 5) button to access the remaining functions. → Functions

After you press a button such as TIMBRE EDIT, the FUNCTION 5 button becomes the HOME button. Press the HOME (FUNCTION 5) button to access the home page.

Edit page

 

 

Use the respective pages to make detailed edits to the OSC, EG, LFO, effects and so on.

1Press the respective buttons in the following sections to show each edit page.

TIMBRE EDIT, EDIT, VOCAL PROCESSOR, EFFECT, EQ

Long-press: TIMBRE [TIMBRE MIX], VOCAL PROCESSOR [VOCAL SETTING], EFFECT [EFFECT ROUTING], , [LOOP SETTING A, B]

2If there are multiple pages, pressing a button multiple times will cycle through them (a tab indicating the currently selected page will appear at the top of the display).

Tip: The pages switch in reverse order while you are holding down the HOME (FUNCTION 5) button.

 

3Use the EDIT CONTROL 1–5 knobs to increase or decrease the parameter values. Use the INC and DEC buttons to increase or decrease the values by one step.

Knobs on the display and EDIT CONTROL 1–5 knobs

The color in the center of the knobs on the display change as follows.

Gray: all knobs aside from the one you last used

 

 

Same color as the knob itself: indicates the last knob used

 

 

Slightly lighter than the knob itself: last knob used; value is equal to the saved value.

 

 

Tip: You can change how the knobs behave when the internal value doesn't match the position of the knob with the “Knob Mode” parameter on the EDIT CONTROL page. → Details