In the global settings, you can configure the pad velocity sensitivity, the volume of the metronome during recording and the auto power-off time.
Global settings: overview of operations
1Press the MODE button to select pattern play mode (the PATTERN LED lights up).
2Long-press the TAP and MODE buttons.
The 1–3 buttons blink, and the unit enters global settings mode.
3 Use the 1–3 buttons (pads) to select the settings you want to change.
The button you press lights up, and the setting’s value appears in the display.
Button 1: pad velocity sensitivity →Adjusting the pad velocity sensitivity
Button 2: metronome volume for recording →Adjusting the metronome volume for recording
Button 3: auto power-off time →Setting the auto power-off feature
4Use the tempo knob to set the value.
5Long-press the TAP and MODE buttons to save all three settings together.
The unit returns to pattern play mode.
|
|
If you turn the power off without saving the settings, the settings are not saved. |
Adjusting the pad velocity sensitivity
You can adjust how much the volume changes according to how hard you tap the 1–14 buttons and the FILL 1, 2 buttons in pad play mode and pattern edit mode.
•A value of 0 makes the pads play at maximum volume, regardless of how hard or soft you play the keys.
•A value of 1–15 makes the pads play at lower volumes when you tap softer, and at higher volumes when you tap harder. Larger values allow for more intricate changes in volume.
Factory default value: 0 (velocity disabled)
Adjusting the metronome volume for recording
This sets the volume that the digital metronome plays while recording from a value of 0 to 15.
During recording, only the digital metronome plays, without following a specific number of beats per measure.
•A setting of 0 mutes the sound, and a setting of 15 plays the sound at full volume.
Factory default setting: 15
Setting the auto power-off feature
This specifies the time required before the auto power-off operates.
•Auto power-off is disabled when this is set to “off”, and the 20–240 settings indicate the number of hours.
Factory default setting: 20 minutes