OASYS PCI and Vision DSP/Studio Vision Pro
OASYS PCI Website
Contents
Vision DSP or Studio Vision Pro 4.2 required
Vision DSP or Studio Vision Pro 4.2 required
Vision DSP (any version), or Studio Vision Pro 4.2 or later, are required for use with the OASYS PCI.
Configuring Vision
Before using OASYS PCI with Vision, you'll need to set up OASYS PCI for use with OMS. For information and detailed instructions, please see OASYS PCI and OMS.
If you will be using OASYS PCI as your main audio I/O hardware, start by setting up OASYS PCI as an OMS device, and then move on to Configuring Audio. When you've completed those steps, you're done.
If you will be using OASYS PCI as a synthesizer and effects processor in conjunction with another audio I/O card, such as the MOTU 2408, start by setting up OASYS PCI as an OMS device. Next, check out the information in Using OASYS PCI with Other Audio Cards. After that, you're done!
Configuring Audio
Select OASYS PCI as the ASIO device
To configure Vision DSP/SV Pro for use with the OASYS PCI as the audio hardware:
1. Open Vision DSP/SV Pro.
2. In Vision DSP/SV Pro, under Audio>Audio System, select Acadia. This enables Opcode's Acadia audio system.
3. In Audio>Hardware Setup, select the OASYS PCI from the Devices pop-up menu.
Vision may take quite a while to update after this step - up to one or two minutes. It takes so long that you might think that the computer has crashed, but don't be concerned; it will come back eventually. Consider this time as an opportunity for a rare moment of peaceful introspection.
4. In the Audio Instruments & Routings Window, enable the inputs and outputs that you'd like to use by placing a check-mark next to their names.
The OASYS PCI will now be available for use in Vision DSP/SV Pro.
Record monitoring
To use the OASYS PCI's zero-latency monitor mixer with Vision DSP/SV Pro:
1. In the Audio Record Monitor window, set Thru to Off.
2. Select Hardware Setup in the Audio menu.
3. In the Hardware Setup dialog box, press the Open Control Panel button.
The OASYS PCI ASIO Control Panel appears.
4. Set the monitor mixer levels and outputs, as desired.
For general information on the OASYS PCI and record monitoring, see ASIO Record Monitoring.
Copyright 1999-2002 Korg Inc. FAQ Version: 8/19/02